Dried Glue on the Table Saw

Hi all! I am relatively new to woodworking, so forgive me if this is a stupid question (but figured it’s worth asking in the interest of being cautious!).

I am working on a project that involves 3 sheets of plywood that have been glued together. I’d like to make a single cut through these three sheets on the table saw. Will this cut trip the brake cartridge?

No harm in asking! :slight_smile:

If the glue is fully dried, you’re good to go.

1 Like

The panel saw might also be an option for you, although I’m not sure what the max thickness for it is.

1 Like